Configuration¶

If you want to avoid entering credentials for every submit or want to setup your favourite language, it is advised to properly configure after installation.

To see help about configuration use spoj config –help. This will display output similar to following

Usage: spoj config [OPTIONS]

Options:
  -l, --language [1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|17|18|19|20|21|22|23|24|25|26|27|28|29|30|31|32|33|34|35|36|38|39|41|42|46|54|56|62|98|99|104|111|114|116|124|126]
                                  Choose Default Language. See `spoj
                                  language`
  -c, --credential
  --help                          Show this message and exit.

Credentials¶

To store your credentials use spoj config -c/–credential. After running this command, few prompt will appear

Username: - Enter your SPOJ username here
Password: - Enter your SPOJ password here
Confirm Password: - Enter your SPOJ password again for confirmation.

After these three prompts, your password will be verified with SPOJ server and after verification your credentials will be remembered and will not be asked again while submitting.

Note

Your credentials are stored on your PC in a configuration file. We do not save or store your credentials on any server on internet.

Language¶

To mark your favourite programming language, use spoj config -l/–language <language code>. The language code should be an integer and should be available in the list produced by spoj language. For details see command spoj language.